Washer Signal Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The headlight cleaner control relay receives the windshield washer operation signal.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK OPERATION |
Check the operation of the front wiper and washer system (Click here).
- OK:
- Front wiper and washer system operates normally.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY) |
Disconnect the A38 headlight cleaner control relay connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A38-5 (FRWA) - Body ground
Ignition switch ON, front washer switch on
Below 1 V
A38-5 (FRWA) - Body ground
Ignition switch ON, and front washer switch off
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Headlight Cleaner Control Relay)
|
|
||||
| OK | ||
| ||
