INSTALLATION
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL YAW RATE AND ACCELERATION SENSOR |
for Automatic Transmission:
Attach the clamp to the hole of the sensor bracket.
Connect the connector.
- NOTICE:
- Securely connect the connector.
Install the yaw rate and acceleration sensor with the 2 bolts.
- Torque:
- 15 N*m{ 148 kgf*cm , 11 ft.*lbf }
- NOTICE:
- If the sensor is dropped, replace it.
- Make sure the bracket rotation stopper touches the installation position.
- Make sure that the sensor is oriented correctly.
- When installing the sensor, make sure to avoid impacts to the sensor.
- If the sensor is dropped, replace it.
| 2. INSTALL CENTER FLOOR CARPET ASSEMBLY (for Bench Seat Type) |
Install the center floor carpet assembly with the 4 bolts.
- Torque:
- 7.0 N*m{ 71 kgf*cm , 61 in.*lbf }
| 3. INSTALL FRONT SEAT ASSEMBLY (for Bench Seat Type) |
| 4. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY |
for Automatic Transmission:
(Click here)
for Manual Transmission:
(Click here)
w/ Refrigerated Cool Box:
(Click here)
for Bench Seat Type:
(Click here)
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 6. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION |
for Hydraulic Brake Booster:
(Click here)
for Vacuum Brake Booster:
(Click here)
| 7. CHECK YAW RATE AND ACCELERATION SENSOR SIGNAL |
for Hydraulic Brake Booster:
(Click here)
for Vacuum Brake Booster:
(Click here)
