Do not replace the spiral cable with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with the battery connected and the ignition switch ON.
Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
Do not remove the steering angle sensor from the spiral cable.
2.
INSTALL STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column: (Click here)
for Power Tilt and Power Telescopic Steering Column: (Click here)
3.
ADJUST SPIRAL CABLE
Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.
CAUTION:
Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.
Rotate the spiral cable sub-assembly with steering sensor clockwise approximately 2.5 turns to align the marks so that the colored part or the flat cable shown in the illustration is visible.
Text in Illustration
*A
w/o Steering Heater
*B
w/ Steering Heater
*1
Alignment Mark
*2
Colored Part
*3
Flat Cable
CAUTION:
Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.
HINT:
The spiral cable sub-assembly with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.