2013-2015 Land Cruiser Prado · Service Manual Brake

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
(Click here)

NOTICE:
  1. Do not replace the spiral cable with the battery connected and the ignition switch ON.
  2. Do not rotate the spiral cable with the battery connected and the ignition switch ON.
  3. Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
  4. Do not remove the steering angle sensor from the spiral cable.


2. INSTALL STEERING COLUMN COVER
  1. for Manual Tilt and Manual Telescopic Steering Column:
    (Click here)

  1. for Power Tilt and Power Telescopic Steering Column:
    (Click here)


3. ADJUST SPIRAL CABLE
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. B181594
    Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.

    CAUTION:
    Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.

  1. B359176E01
    Rotate the spiral cable sub-assembly with steering sensor clockwise approximately 2.5 turns to align the marks so that the colored part or the flat cable shown in the illustration is visible.
    Text in Illustration 
    *A
    w/o Steering Heater
    *B
    w/ Steering Heater
    *1
    Alignment Mark
    *2
    Colored Part
    *3
    Flat Cable

    CAUTION:
    Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.

    HINT:
    The spiral cable sub-assembly with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.


4. INSTALL STEERING WHEEL ASSEMBLY
(Click here)

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


6. CHECK SRS WARNING LIGHT
(Click here)
← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →