HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the theft deterrent system.
- *: Use the intelligent tester.
- The troubleshooting procedures for the theft deterrent system are based on the premise that the door lock control system, wireless door lock control system, lighting system, horn system, engine immobiliser system and entry and start system (w/ Entry and Start System) are operating normally. Check these systems first before troubleshooting the theft deterrent system.
- Use these procedures to troubleshoot the theft deterrent system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD with Entry and Start System)
B
CAN DTC is output (for LHD without Entry and Start System)
C
CAN DTC is output (for RHD with Entry and Start System)
D
CAN DTC is output (for RHD without Entry and Start System)
E
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
The theft deterrent system uses the LIN communication system to communicate. Check that the LIN communication system is functioning normally.
Result Result
Proceed to
LIN communication system is normal
A
LIN communication system is malfunctioning
B
|
|||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs (Click here) and note any codes that are output.
Clear the DTCs (Click here).
Based on the DTCs output above, try to force output of the same DTC by simulating the symptoms indicated by the DTC. Then recheck for DTCs.
Result Result
Proceed to
DTC output does not reoccur
A
DTC output reoccurs
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
Inspection
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||