2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. When the engine immobiliser system is set, the security indicator light blinks continuously, but does not illuminate if the engine immobiliser system is not set.

WIRING DIAGRAM

B242452E07

INSPECTION PROCEDURE

NOTICE:
When replacing the transponder key ECU assembly, refer to the Service Bulletin.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT)
  1. Check that the security indicator light illuminates when operating it with the Active Test (Click here).

    Immobiliser 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON/OFF
    The test is possible when the following conditions are met:
    1. The key is in the ignition key cylinder.

    OK:
    Security indicator light can be turned on and off using the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT SECURITY INDICATOR LIGHT ASSEMBLY

  1. B238374E01
    Remove the security indicator light assembly (Click here).

  1. Apply battery voltage between the terminals of the security indicator light assembly and check that the security indicator light illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2 (LP)
    Battery negative (-) → 5 (E)
    Security indicator light illuminates



NG
REPLACE SECURITY INDICATOR LIGHT ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR - TRANSPONDER KEY ECU AND BODY GROUND)
  1. Disconnect the H23 light connector.

  1. Disconnect the G138*1 or G74*2 ECU connector.

    1. *1: for 5L-E
    2. *2: except 5L-E

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 5L-E 
    Tester Connection
    Condition
    Specified Condition
    H23-2 (LP) - G138-8 (IND)
    Always
    Below 1 Ω
    H23-5 (E) - Body ground
    Always
    Below 1 Ω
    H23-2 (LP) or G138-8 (IND) - Body ground
    Always
    10 kΩ or higher
    except 5L-E 
    Tester Connection
    Condition
    Specified Condition
    H23-2 (LP) - G74-8 (IND)
    Always
    Below 1 Ω
    H23-5 (E) - Body ground
    Always
    Below 1 Ω
    H23-2 (LP) or G74-8 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY


← Security Indicator Light Circuit (Aug 2013 – Jul 2014)ECU Power Source Circuit (Aug 2013 – Jul 2014) →