Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › ECD SYSTEM (w/o DPF)
MIL Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL. The MIL operation can be checked visually. When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off when the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester. WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
After replacing the ECM, the new ECM needs registration (Click here ) and initialization (Click here ).
1. CHECK THAT MIL IS ILLUMINATED
Check the MIL illumination condition.
Result
Condition
Proceed to
MIL remains on
A
MIL does not illuminate
B
B
A
2. CHECK WHETHER MIL TURNS OFF
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Check if DTCs have been stored (Click here ). If DTCs are output, write them down.
Clear DTCs (Click here ).
Check that the MIL turns off.
OK:
MIL turns off.
NG
OK
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here )
3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
OK:
MIL is not illuminated.
Reconnect the ECM connector.
NG
OK
4. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
Tester Connection
Condition
Specified Condition
G7-7 (CHK) - G57-19 (W)
Always
Below 1 Ω
Standard Resistance (Check for Short):
Tester Connection
Condition
Specified Condition
G7-7 (CHK) or G57-19 (W) - Body ground
Always
10 kΩ or higher
Reconnect the ECM connector.
Reconnect the combination assembly meter connector.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5. CHECK THAT MIL IS ILLUMINATED
Check if the MIL is illuminated when the ignition switch is turned to ON.
OK:
MIL is illuminated.
NG
OK
6. CHECK THAT ENGINE STARTS
Turn the ignition switch to ON.
Start the engine.
Result
Result
Proceed to
Engine starts
A
Engine does not start*
B
HINT:
*: The intelligent tester cannot communicate with the ECM.
B
A
7. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
Refer to the combination meter troubleshooting procedure (Click here ).
Result
Result
Proceed to
NG
A
OK
B
B
A
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER ASSEMBLY - ECM)