2013-2015 Land Cruiser Prado · Service Manual Brake

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the anti-lock brake system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the trouble.

    NEXT

    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    4.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record output DTCs and the freeze frame data.

    2. Clear the DTCs and freeze frame data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

    3. Reconfirm the DTC.

      1. Reconfirm the DTCs based on the recorded output DTCs and freeze frame data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

        HINT:
        If DTC U0073, U0114 or U0124 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).

        Result 
        Result
        Proceed to
        DTC output
        A
        DTC not output (Problem symptom does not occur)
        B
        DTC not output (Problem symptom occurs)
        C


    B.

    C.
    A

    5.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).

    NEXT

    6.SYMPTOM SIMULATION
    1. Proceed to Check for Intermittent Problems (Click here).

    NEXT

    7.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).

    NEXT

    8.CIRCUIT INSPECTION*
      NEXT

      9.IDENTIFICATION OF PROBLEM
        NEXT

        10.REPAIR OR REPLACEMENT
          NEXT

          11.CONFIRMATION TEST*
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)CHECK FOR INTERMITTENT PROBLEMS (from Aug 2013) →