2013-2015 Land Cruiser Prado · Service Manual Brake

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

NOTICE:
When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.

Anti-lock Brake System 
Symptom
Suspected Area
See page
ABS, BA and/or EBD does not operate
Check for DTCs again and make sure that normal system code is output.
Click here
IG power source circuit (low power supply voltage malfunction)
Click here
IG power source circuit (high power supply voltage malfunction)
Click here
Front speed sensor circuit (comparison malfunction)
Click here
Front speed sensor circuit (open or short malfunction)
Click here
Front speed sensor circuit (output malfunction)
Click here
Rear speed sensor circuit (comparison malfunction)
Click here
Rear speed sensor circuit (open or short malfunction)
Click here
Rear speed sensor circuit (output malfunction)
Click here
Check brake actuator assembly with the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks.
Click here
If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU)
Click here
ABS, BA and/or EBD does not operate efficiently
Check for DTCs again and make sure that normal system code is output
Click here
Front speed sensor circuit (comparison malfunction)
Click here
Front speed sensor circuit (open or short malfunction)
Click here
Front speed sensor circuit (output malfunction)
Click here
Rear speed sensor circuit (comparison malfunction)
Click here
Rear speed sensor circuit (open or short malfunction)
Click here
Rear speed sensor circuit (output malfunction)
Click here
Stop light switch circuit
Click here
Check brake actuator assembly with the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks.
Click here
If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU)
Click here
ABS warning light abnormal (Remains on)
ABS warning light circuit
Click here
IG power source circuit (high power supply voltage malfunction)
Click here
Brake actuator assembly (skid control ECU)
Click here
ABS warning light abnormal (Does not come on)
ABS warning light circuit
Click here
Brake actuator assembly (skid control ECU)
Click here
Brake warning light abnormal (Remains on)
Brake warning light circuit
Click here
IG power source circuit (high power supply voltage malfunction)
Click here
Brake actuator assembly (skid control ECU)
Click here
Brake warning light abnormal (Does not come on)
Brake warning light circuit
Click here
Brake actuator assembly (skid control ECU)
Click here
DTC check cannot be performed
Check for DTCs again and make sure that normal system code is output
Click here
TC and CG terminal circuit
Click here
IG power source circuit (high power supply voltage malfunction)
Click here
If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU)
Click here
Sensor check cannot be performed
TS and CG terminal circuit
Click here
Brake actuator assembly (skid control ECU)
Click here
← PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014)TERMINALS OF ECU (from Aug 2013) →