C1337 Diameter of the Tire is not Uniform
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors.These signals are used for recognizing that all 4 wheels are operating properly.
Therefore, all wheel signals must indicate the same speed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1337 |
The following occurs in 3 consecutive trips: At a vehicle speed of 20 km/h (12 mph) or more, there is a difference of 20% or more in the average speed between the front wheels and rear wheels for 20 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
- HINT:
- When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (Click here).
| 1. CHECK TIRES |
Check the size and condition of all 4 wheels (Click here).
- HINT:
- The DTC is output when tire deformation or a difference in tire size is detected.
- OK:
- The diameter and air pressure of all 4 tires are the same.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1337 is output
A
DTC C1337 is not output
B
|
|
||||
| A | ||
| ||
