C1421 Open or Short in Master Cylinder Pressure Sensor
Diagnostic trouble codes · Vehicles built from Aug 2013
Also covers:
- C1281 Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)
- C1423 Master Cylinder Pressure Sensor Zero Point Low Malfunction
- C1424 Master Cylinder Pressure Sensor Output Malfunction
- C1455 Open or Short in Control Pressure Sensor
- C1457 Control Pressure Sensor Zero Point Low
- C1458 Control Pressure Sensor Zero Point Output
DESCRIPTION
The pressure control sensor and master cylinder pressure sensor are connected to the skid control ECU in the master cylinder solenoid.

| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1421 |
Either condition is met: Both of the following conditions continue for at least 1.2 seconds.
|
Master cylinder solenoid (Master cylinder pressure sensor, skid control ECU) |
| C1423 |
Both of the following conditions continue for at least 5 seconds
|
Master cylinder solenoid (Master cylinder pressure sensor, skid control ECU) |
| C1424 |
One of the following conditions is met:
|
Master cylinder solenoid (Master cylinder pressure sensor, skid control ECU) |
| C1281 |
Detected only during Test Mode |
Master cylinder solenoid (Master cylinder pressure sensor, skid control ECU) |
| C1455 |
The IG1 terminal voltage is 9.5 V or higher and the PCTRL terminal voltage is outside the range of 0.19 to 4.57 V for 1.2 seconds. |
Master cylinder solenoid (Pressure control sensor, skid control ECU) |
| C1457 |
The PCTRL terminal voltage is below 0.3 V for 5 seconds. |
Master cylinder solenoid (Pressure control sensor, skid control ECU) |
| C1458 |
One of the following conditions is met:
|
Master cylinder solenoid (Pressure control sensor, skid control ECU) |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. REPLACE MASTER CYLINDER SOLENOID |
Replace the master cylinder solenoid (for LHD: Click here, for RHD: Click here).
| NEXT | ||
| ||
