C1420 Acceleration Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
Refer to DTCs C1419 and C1435 (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1420 |
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and acceleration sensor, perform calibration (Click here).
- HINT:
- When DTC U0123, U0124 and/or U0126 is output together with DTC C1420, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (Click here).
| 1. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION |
Check that the yaw rate and acceleration sensor is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | ||
| ||
