B2620 ECU Power Source Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The ECU power source circuit supplies positive voltage to the multiplex tilt and telescopic ECU.| DTC Code |
Detection Condition |
Trouble Area |
| B2620 |
The ECU power source voltage drops to 8 V or less for 10 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY) |
Disconnect the G116 multiplex tilt and telescopic ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
G116-9 (ECUB) - Body ground
Always
11 to 14 V
Text in Illustration *a
Rear view of wire harness connector
(to Multiplex Tilt and Telescopic ECU)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
G116-11 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Rear view of wire harness connector
(to Multiplex Tilt and Telescopic ECU)
|
|
||||
| OK | ||
| ||
