2013-2015 Land Cruiser Prado · Service Manual Steering

B2621 Communication Interruption

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the CAN communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the CAN communication bus on a regular schedule. The multiplex tilt and telescopic ECU detects the connection of each ECU based on the signal.
DTC Code
Detection Condition
Trouble Area
B2621
The periodic signal from a specified ECU has stopped.
  1. CAN communication system
  2. Multiplex tilt and telescopic ECU

INSPECTION PROCEDURE


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs of the CAN communication system.for LHD with Entry and Start System:Refer to the following procedures (Click here).for RHD with Entry and Start System:Refer to the following procedures (Click here).

    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    for LHD with Entry and Start System
    B
    for RHD with Entry and Start System
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)


← B2620 ECU Power Source Circuit Malfunction (from Aug 2014)B2621 Communication Interruption (from Aug 2014) →