Slip Indicator Light does not Come ON
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
Refer to Slip Indicator Light Remains ON (Click here)WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (Click here).INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the brake actuator assembly, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).
Result Result
Proceed to
DTC not output
A
DTC output
for LHD without Entry and Start System
B
DTC output
for RHD without Entry and Start System
C
|
|
||||
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Slip Indicator Light
Slip indicator light / ON or OFF
OFF
-
When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List (Click here).
| Tester Display |
Test Part |
Control Range |
Diagnostic Note |
| Slip Indicator Light |
Slip indicator light |
Indicator light ON/OFF |
Observe the combination meter. |
| Result |
Proceed to |
|
| Data List Display |
Data List Display when Performing Active Test ON/OFF Operation |
|
| ON |
Does not change between ON and OFF |
A |
| Changes between ON and OFF |
B |
|
| OFF |
Does not change between ON and OFF |
A |
| Changes between ON and OFF |
B |
|
|
|
||||
| A | ||
| ||
