VSC Buzzer Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.The combination meter assembly has a built-in buzzer.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform calibration (Click here).
| 1. CHECK CAN COMMUNICATION LINE |
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).
Result Result
Proceed to
DTC not output
A
DTC output
for LHD without Entry and Start System
B
DTC output
for RHD without Entry and Start System
C
|
|
||||
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (BUZZER) |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Buzzer |
Buzzer/ ON or OFF |
ON: Buzzer on OFF: Buzzer off |
The combination meter has a built-in buzzer. |
When performing the Buzzer Active Test, check Buzzer in the Data List (Click here).
| Tester Display |
Test Part |
Control Range |
Diagnostic Note |
| Buzzer |
Buzzer |
Buzzer ON/OFF |
The buzzer can be heard. |
| Result |
Proceed to |
|
| Data List Display |
Data List Display when Performing Active Test ON/OFF Operation |
|
| ON |
Changes between ON and OFF |
A |
| Does not change between ON and OFF |
B |
|
| OFF |
Changes between ON and OFF |
A |
| Does not change between ON and OFF |
B |
|
|
|
||||
| A | ||
| ||
| 3. INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
|
|
||||
| OK | ||
| ||
