C1437 Lost Communication with ECM
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU receives signals from the ECM via the CAN communication system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1437 |
When the IG1 terminal voltage is 10 V or higher and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent from the ECM for 2 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the intelligent tester, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
EFI Communication Open
EFI communication open detection/ Error or Normal
Normal
-
- OK:
- Normal (there are no momentary interruptions).
- HINT:
- Perform the above inspection before removing the sensor and connector.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1437 is not output
A
DTC C1437 is output (for 1GR-FE)
B
DTC C1437 is output (for 1KD-FTV)
C
CAN communication system DTC is output (for LHD)
D
CAN communication system DTC is output (for RHD)
E
- HINT:
- For 1KD-FTV, refer to the following sections.
- w/ DPF: Click here
- w/o DPF: Click here
- w/ DPF: Click here
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
| 3. REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU - ECM) |
Turn the ignition switch off.
Repair or replace the harness or connector.
Check for any momentary interruption between the skid control ECU and ECM (Click here).
Check that there is no momentary interruption.
| NEXT | |
| 4. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1437 is not output
A
DTC C1437 is output (for LHD)
B
DTC C1437 is output (for RHD)
C
CAN communication system DTC is output (for LHD)
D
CAN communication system DTC is output (for RHD)
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
