Home › Engine / Hybrid System › 5L-E ENGINE CONTROL › ECD SYSTEM
MIL Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The MIL is used to inform the user when the ECM has detected a vehicle malfunction. By turning the ignition switch to ON, power is supplied to the MIL circuit and the ECM provides the circuit ground that illuminates the MIL. Operation of the MIL should be checked visually: When the ignition switch is first turned to ON, the MIL should illuminate. When the engine is started, the MIL should turn off. WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK MIL CONDITION
Check the MIL condition.
Result:
Condition
Proceed to
MIL remains on
A
MIL does not illuminate
B
B
A
2. CHECK IF MIL TURNS OFF
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Check if DTCs have been stored (Click here ). If DTCs are stored, write them down.
Clear the DTCs using the intelligent tester (Click here ).
Check that the MIL turns off.
OK:
The MIL turns off.
NG
OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here )
3. CHECK HARNESS AND CONNECTOR (FOR SHORT)
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
OK:
The MIL is not illuminated.
Text in Illustration
*a
Rear view of wire harness connector (to ECM)
Reconnect the ECM connector.
NG
OK
4. CHECK HARNESS AND CONNECTOR (ECM - COMBINATION METER ASSEMBLY)
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
Tester Connection
Condition
Specified Condition
G61-5 (W) - G7-7 (CHK)
Always
Below 1 Ω
Standard Resistance (Check for Short):
Tester Connection
Condition
Specified Condition
G61-5 (W) or G7-7 (CHK) - Body ground
Always
10 kΩ or higher
Reconnect the ECM connector.
Reconnect the combination meter assembly connector.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5. CHECK IF MIL ILLUMINATES
Check that the MIL illuminates when turning the ignition switch to ON.
OK:
The MIL illuminates.
NG
OK
6. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
Refer to the combination meter assembly troubleshooting procedures (Click here ).
NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY (Click here )
OK
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM)