2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL INJECTION PUMP ASSEMBLY
  1. Temporarily install the injection pump to the timing gear case with the 2 nuts.

  1. Temporarily install the injection pump stay to the injection pump rear end with the 3 bolts.

  1. A071319E01
    Rotate the pump body to align the marks on the pump flange and timing gear case.

  1. Tighten the 2 nuts.

    Torque:
    21 N*m{ 209 kgf*cm , 15 ft.*lbf }

  1. Tighten the 3 bolts.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }

  1. A223881
    Connect the 3 fuel hoses.

  1. Connect the 5 connectors and attach the wire harness clamp.


2. INSTALL INJECTION PUMP DRIVE PULLEY

  1. A071313E01
    Using SST, install the injection pump drive pulley with the nut.
    SST
    09213-14010   (91651-60865)
    09330-00021  

    Torque:
    64 N*m{ 650 kgf*cm , 47 ft.*lbf }


3. INSTALL INJECTION PIPE SET
  1. Install the 2 lower clamps to the intake manifold.

  1. A230069E01
    Install the 4 injection pipes.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

    Text in Illustration 
    *a
    for Injection Nozzle Side
    *b
    for Injection Pump Side

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. Install the 2 upper pipe clamps with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }


4. INSTALL DIESEL THROTTLE BODY
  1. Install the diesel throttle body (Click here).


5. INSTALL TIMING BELT
  1. Install the timing belt (Click here).


6. BLEED INJECTION PIPE
  1. Move the hand pump on the upper part of the fuel filter up and down and fill the injection pump and fuel system with fuel.

  1. Loosen one of the union nuts (on the nozzle side).

  1. Crank the engine until fuel comes out from the union nut connection (on the nozzle side).

  1. Tighten the union nut.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. Perform the procedures above for each injection pipe.

← REASSEMBLY (from Aug 2013)INSTALLATION (from Aug 2014) →