B1244 Light Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The automatic light control sensor detects ambient light, converts it into an electrical signal and outputs it to the main body ECU. The main body ECU turns the headlights and taillights on or off according to the signal.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1244 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1244 output does not occur.
|
|
||||
| OK | ||
| ||
| 2. READ VALUE USING INTELLIGENT TESTER (AUTOMATIC LIGHT CONTROL SENSOR) |
Using the intelligent tester, read the Data List (Click here).
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Illumination Rate
Illumination rate information / 0 ms. to 99.99 ms.
Value output according to ambient light levels
-
- OK:
- Normal condition listed above is displayed.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - AUTOMATIC LIGHT CONTROL SENSOR) |
Disconnect the G64 main body ECU connector.
Disconnect the H19 automatic light control sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G64-22 (CLTE) - H19-3 (CLTE)
Always
Below 1 Ω
G64-21 (CLTS) - H19-5 (CLTS)
Always
Below 1 Ω
G64-20 (CLTB) - H19-6 (CLTB)
Always
Below 1 Ω
G64-22 (CLTE) - Body ground
Always
10 kΩ or higher
G64-21 (CLTS) - Body ground
Always
10 kΩ or higher
G64-20 (CLTB) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Reconnect the G64 main body ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
G64-20 (CLTB) - G64-22 (CLTE)
Ignition switch off
Below 1 V
Ignition switch ON and headlight dimmer switch in AUTO position
11 to 14 V
Text in Illustration *a
Component with harness connected
(Main Body ECU)
|
|
||||
| OK | |
| 5. CHECK AUTOMATIC LIGHT CONTROL SENSOR |
Reconnect the H19 automatic light control sensor connector.

Connect an oscilloscope to the automatic light control sensor connector.
Text in Illustration *a
Component with harness connected
(Automatic Light Control Sensor)
Check the waveform.

- OK:
Tester Connection
Tool Setting
Switch Condition
Specified Condition
H19-5 (CLTS) - H19-3 (CLTE)
5 V/DIV., 5 ms./DIV.
Ignition switch ON
Headlight dimmer switch AUTO Automatic light control sensor covered with a hand → Automatic light control sensor exposed to ambient light
Correct waveform is as shown
- HINT:
- When the ambient light becomes brighter, width A becomes narrower.
|
|
||||
| OK | ||
| ||
