2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
  1. Remove the manual transmission (Click here).


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
  1. Remove the automatic transmission (Click here).


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

C215513E01
  1. Place matchmarks on the clutch cover and flywheel.

    Text in Illustration 
    *a
    Matchmark

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.


4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.


5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. A225337E01
    Using SST, hold the crankshaft pulley.
    SST
    09213-58014  
    09330-00021  

  1. Remove the 8 bolts and flywheel.


6. REMOVE PUMP IMPELLER DRIVE PLATE (for Automatic Transmission)

  1. A225337E01
    Using SST, hold the crankshaft pulley.
    SST
    09213-58014  
    09330-00021  

  1. A225158
    Remove the 8 bolts, the rear drive plate spacer, the pump impeller drive plate and the flywheel and ring gear.


7. REMOVE REAR CRANKSHAFT OIL SEAL

  1. A225345E01
    Using a knife, cut off the lip of the rear crankshaft oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the rear crankshaft oil seal.

    NOTICE:
    Be careful not to damage the crankshaft.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →