Radio Broadcast cannot be Received or Poor Reception
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
Check the radio automatic station search function by activating it.
OK:
Automatic station search function stops on a station.
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)
3. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
Remove the antenna connector from the radio and display assembly.
Turn the ignition switch to ACC with the radio and display assembly connector connected.
Turn on the radio and turn into AM mode.
Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.
OK:
Noise occurs.
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)