Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)
Radio Broadcast cannot be Received or Poor Reception
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
Check the radio automatic station search function by activating it.
OK:
Automatic station search function stops on a station.
NG
OK
2. CHECK OPTIONAL COMPONENTS
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
OK:
Optional components are installed.
NOTICE:
Do not remove optional components without permission of the customer.
NG
OK
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)
3. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
Remove the antenna connector from the radio and display receiver assembly.
Turn the engine switch on (ACC) with the radio and display receiver assembly connector connected.
Turn on the radio and turn into AM mode.
Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.
OK:
Noise occurs.
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here )
OK
4. INSPECT QUARTER WINDOW ASSEMBLY (WINDOW GLASS ANTENNA WIRE)
Inspect the quarter window assembly (window glass antenna wire) (Click here ).
NG
OK
5. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
Disconnect the RA radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
5 (ANT+) - Body ground
Engine switch on (ACC) Radio switch on
11 to 14 V
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here )
OK
6. CHECK NO. 2 ANTENNA CORD SUB-ASSEMBLY
Disconnect the antenna connector from the radio and display receiver assembly.
Disconnect the antenna connector from the holder antenna assembly.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
RA-3 (RMAIN2) - 3
Always
Below 1 Ω
RA-5 (ANT+) - 1
Always
Below 1 Ω
RA-3 (RMAIN2) - Body ground
Always
10 kΩ or higher
RA-5 (ANT+) - Body ground
Always
10 kΩ or higher
Text in Illustration
*a
Front view of wire harness connector (to Radio and Display Receiver Assembly)
*b
Front view of wire harness connector (to Holder Antenna Assembly)
NG
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY (Click here )
OK
7. CHECK HOLDER ANTENNA ASSEMBLY
Replace the holder antenna assembly and check if radio broadcasts can be received normally (Click here ).
OK:
Radio broadcasts can be received.
NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here )
OK
END (HOLDER ANTENNA ASSEMBLY IS DEFECTIVE)