Driver Side Seat Belt Warning Light does not Operate
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
When the ignition switch is turned to ON, the center airbag sensor transmits front seat inner belt LH*1 (or RH*2) state signals to the combination meter through the CAN. If the driver side seat belt is not fastened, the combination meter blinks the front seat belt warning light. If the seat belt is fastened, the warning light goes off.- HINT:
- The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.
- *1: for LHD
- *2: for RHD
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure (Click here).
| 1. CHECK FOR DTC (AIRBAG SYSTEM) |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
Airbag system DTC is output
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DRIVER SIDE SEAT BELT WARNING LIGHT) |
Operate the intelligent tester according to the display and select Active Test (Click here).
Combination Meter Item
Test Part
Control Range
Diagnostic Note
Driver Side Seat Belt
Front seat belt warning light
ON/OFF
Confirm that the vehicle is stopped and the engine is idling.
- OK:
- Driver side seat belt warning light condition can be switched by Active Test.
|
|
||||
| OK | |
| 3. REPLACE CENTER AIRBAG SENSOR ASSEMBLY |
Temporarily replace the center airbag sensor with a new one (Click here).
| NEXT | |
| 4. CHECK DRIVER SIDE SEAT BELT WARNING LIGHT |
Check the driver side seat belt warning light function (Click here).
- OK:
- Driver side seat belt warning light operates normally.
|
|
||||
| OK | ||
| ||
