2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the screw and terminal 50 wire.

  1. A222267E01
    Remove the nut and disconnect the terminal C wire.
    Text in Illustration 
    *1
    Terminal C

  1. Remove the 2 through bolts and O-rings and pull out the starter yoke with the armature.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A222268
    Remove the 2 screws and magnet starter switch.

  1. Remove the return spring.

  1. B000464E04
    Remove the starter clutch, starter armature pinion, starter idle pinion, retainer and clutch roller from the starter drive housing.
    Text in Illustration 
    *1
    Starter Clutch
    *2
    Starter Armature Pinion
    *3
    Starter Idle Pinion
    *4
    Retainer
    *5
    Clutch Roller

  1. P005056E03
    Using a magnet hand, remove the steel ball from the clutch shaft hole.
    Text in Illustration 
    *1
    Magnet Hand


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. N000562E01
    Disconnect the 4 brushes from the starter brush holder.

    1. Using a screwdriver, hold back the brush spring.

    2. Disconnect the brush from the starter brush holder.

  1. Remove the starter brush holder.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A222477
    Using a plastic-faced hammer, tap the end of the starter yoke and remove the starter armature.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →