2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL STARTER ARMATURE ASSEMBLY

  1. P004699E01
    Using a press, install the starter armature assembly.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. ST00096E06
    Align the claw of the brush holder with the claw groove of the starter yoke.
    Text in Illustration 
    *1
    Claw
    *2
    Groove

  1. Place the brush holder on the starter yoke.

  1. Connect the 4 brushes to the starter brush holder.

    1. Using a screwdriver, hold back the brush spring.

    2. Connect the brush to the starter brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded.


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply high-temperature grease to the starter idle pinion, starter clutch, starter armature pinion, retainer and clutch roller.

  1. A222255
    Insert the steel ball into the starter clutch hole.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.

  1. Install the starter housing to the magnet starter switch with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. A222271E02
    Align the claw of the starter brush holder with the grooves of the magnet starter switch.
    Text in Illustration 
    *1
    Claw
    *2
    Groove

  1. Install the 2 new O-rings to the bolts.

  1. Install the 2 bolts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Connect the terminal C wire with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

  1. Install the terminal 50 wire with the screw.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →