2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL GENERATOR ROTOR ASSEMBLY

  1. A225703E01
    Using SST and a press, press in the generator rotor.
    SST
    09285-76010  

  1. Place the washer on the generator rotor.


2. INSTALL GENERATOR RECTIFIER END FRAME

  1. A220286E01
    Using a 17 mm socket wrench and press, slowly press on the rectifier end frame.
    Text in Illustration 
    *1
    17 mm Socket Wrench

  1. Install the cord clip and 4 nuts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


3. INSTALL GENERATOR HOLDER WITH RECTIFIER

  1. A220287
    Install the 4 rubber insulators to the lead wires.
    Text in Illustration 
    V100135
    Inside

    NOTICE:
    Be careful to install the rubber insulators in the correct direction.

  1. A220288
    While pushing down on the rectifier holder, install it with the 4 screws.

    Torque:
    2.9 N*m{ 30 kgf*cm , 26 in.*lbf }

    Text in Illustration 
    V100135
    Push


4. INSTALL GENERATOR REGULATOR ASSEMBLY
  1. Install the regulator with the 3 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


5. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
  1. Install the plate seal.

  1. A220289
    Install the brush holder with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    Text in Illustration 
    V100135
    Upper

  1. Install the brush holder cover.


6. INSTALL GENERATOR REAR END COVER

  1. A220290E01
    Install the rear end cover and rectifier plate with the bolt and 3 nuts.

    Torque:
    for nut:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }
    for bolt:
    3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

    Text in Illustration 
    *1
    Rectifier Plate

  1. Install the terminal insulator with the nut.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }


7. INSTALL VACUUM PUMP ASSEMBLY
  1. Align the matchmarks and install the vacuum pump with the 4 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →