This circuit sends a signal to the television display assembly to mute noise. Because of that, the noise produced by changing the sound source ceases. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the television display assembly is normal, no sound, or only an extremely small sound, can be produced.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK MUTE SIGNAL CIRCUIT
Remove the television display assembly connector still connected (Click here).
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
W14-6 (MUT1) - Body ground
Television display playing
Above 3.5 V
Television display changing modes
Below 1 V
Text in Illustration
*a
Component with harness connected (Television Display Assembly)