2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit sends a signal to the television display assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the television display assembly is normal, no sound, or only an extremely small sound, can be produced.

WIRING DIAGRAM

E245681E43

INSPECTION PROCEDURE


1. CHECK MUTE SIGNAL CIRCUIT

  1. E201128E12
    Remove the television display assembly connector still connected (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    W14-6 (MUT1) - Body ground
    Television display playing
    Above 3.5 V
    Television display changing modes
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Television Display Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
  1. Disconnect the H57 navigation receiver assembly connector.

  1. Disconnect the W14 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H57-8 (MUTE) - W14-6 (MUT1)
    Always
    Below 1 Ω
    H57-8 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TELEVISION DISPLAY ASSEMBLY
  1. Temporarily replace the television display assembly with a new or known good one (Click here)

  1. Check that the mute signal circuit functioning normally.

    OK:
    The mute signal circuit functioning normally.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END (TELEVISION DISPLAY ASSEMBLY WAS DEFECTIVE)


← Mute Signal Circuit between Radio Receiver and Television Display Assembly (from Aug 2014)Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly (from Aug 2014) →