2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

  1. A224304
    Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.

  1. A226728
    Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.


3. REMOVE INTAKE PIPE

  1. A223437
    Remove the 2 bolts.

  1. Loosen the hose clamp and remove the intake pipe.


4. DISCONNECT VENTILATION HOSE

  1. A225696
    Disconnect the ventilation hose.


5. REMOVE NO. 1 GLOW PLUG CONNECTOR

  1. A224317
    Remove the nut, No. 2 glow plug resistor insulator and washer and disconnect the wire harness.

  1. Remove the 4 screw grommets and 4 nuts.

  1. Remove the No. 1 glow plug connector and No. 1 glow plug resistor insulator.


6. REMOVE GLOW PLUG ASSEMBLY

  1. A224318
    Using a 12 mm deep socket wrench, remove the 4 glow plugs.

← REMOVAL (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →