2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).


2. DISCONNECT VANE PUMP ASSEMBLY

  1. A218388
    Remove the bolt and disconnect the pressure feed tube.

  1. A218387
    Disconnect the 2 connectors.

  1. Remove the 2 bolts and disconnect the vane pump.

    HINT:
    It is not necessary to completely remove the vane pump. With the hoses connected to the vane pump, hang the vane pump on the vehicle body with a rope.


3. DISCONNECT COOLER COMPRESSOR ASSEMBLY

  1. A218390
    Remove the bolt and disconnect the suction hose from the engine.

  1. A218389
    Disconnect the connector.

  1. Remove the 4 bolts and disconnect the cooler compressor.

    HINT:
    It is not necessary to completely remove the cooler compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.


4. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

  1. A099203
    Remove the 5 bolts and No. 1 compressor mounting bracket.


5. REMOVE CRANKSHAFT POSITION SENSOR

  1. A222453
    Disconnect the crankshaft position sensor connector and detach the wire harness clamp.

  1. G037914E02
    Remove the bolt and crankshaft position sensor.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →