B15C2 Speed Signal Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle position.The navigation receiver assembly stores this DTC when the difference between the speed information that the navigation antenna assembly receives and the SPD pulse received from the combination meter assembly becomes large.
- HINT:
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
- If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B15C2 |
A difference between the GPS speed and SPD pulse is detected. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK VEHICLE SENSOR (OPERATION CHECK) |
Enter the "GPS&Vehicle Sensors" (Vehicle Sensors) (Click here).

While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.
- OK:
- The readings are equal or almost equal.
|
|
||||
| OK | ||
| ||
| 2. CHECK COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
Check the output waveform.

Remove the combination meter assembly with the connector(s) still connected (Click here).
Connect an oscilloscope to terminal G6-32 (+S) and body ground.
Turn the engine switch on (IG).
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
Item
Condition
Measurement terminal
G6-32 (+S) - Body ground
Tool setting
5 V/DIV., 20 ms./DIV.
Vehicle condition
Wheel being rotated
- OK:
- The waveform is similar to that shown in the illustration.
- HINT:
- When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
Text in Illustration *a
Component with harness connected
(Combination Meter Assembly)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY) |
Disconnect the H61 navigation receiver assembly connector.
Disconnect the G6 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H61-17 (SPD) - G6-32 (+S)
Always
Below 1 Ω
H61-17 (SPD) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
