2013-2015 Land Cruiser Prado · Service Manual Steering

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING

  1. C132029E05
    Using a micrometer, measure the outer diameter of the vane pump shaft.
    Text in Illustration 
    *a
    Outer Diameter
    *b
    Inner Diameter

  1. Using a vernier caliper, measure the inner diameter of the vane pump front housing bush.

  1. Calculate the oil clearance.
    Oil clearance = Inner diameter of the bush - Outer diameter of the shaft

    Maximum oil clearance:
    0.07 mm (0.00276 in.)

    If the oil clearance is more than the maximum, replace the vane pump assembly.


INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE

  1. C101977E02
    Using a micrometer, measure the thickness of the vane pump plates.

    Standard thickness:
    1.405 to 1.411 mm (0.0554 to 0.0555 in.)
    Text in Illustration 
    *a
    Thickness

    If the thickness is not as specified, replace the vane pump assembly.

  1. C101978E02
    Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plate.

    Maximum clearance:
    0.025 mm (0.00098 in.)
    Text in Illustration 
    *1
    Feeler Gauge

    If the clearance is more than the maximum, replace the vane pump assembly.


INSPECT PRESSURE PORT UNION
If the union seat in the pressure port union is severely damaged, it may cause fluid leakage. In that case, replace the vane pump assembly.
← DISASSEMBLY (from Aug 2013)REASSEMBLY (from Aug 2013) →