2013-2015 Land Cruiser Prado · Service Manual Steering

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. SECURE VANE PUMP ASSEMBLY

  1. C215464E01
    Using SST, secure the vane pump in a vise.
    SST
    09630-00014   (09631-00132)


2. REMOVE SUCTION PORT UNION

  1. C215465
    Remove the bolt and suction port union from the vane pump.

  1. Using a screwdriver, remove the O-ring from the suction port union.


3. REMOVE VANE PUMP REAR HOUSING

  1. C131230
    Remove the 4 bolts and vane pump rear housing from the vane pump front housing.

  1. C107025E03
    Using a screwdriver, remove the O-ring from the vane pump rear housing.


4. REMOVE VANE PUMP SHAFT WITH PULLEY

  1. C131231
    Using 2 screwdrivers, remove the snap ring from the vane pump shaft.

  1. Remove the vane pump shaft with pulley.

    NOTICE:
    Be careful not to drop or damage the vane pump shaft with vane pump pulley.

    If it is damaged, replace the vane pump assembly.


5. REMOVE VANE PUMP ROTOR

C114697
  1. Remove the 10 vane pump plates.

    NOTICE:
    Take care not to drop the vane pump plates.

  1. Remove the vane pump rotor from the vane pump front housing.


6. REMOVE VANE PUMP CAM RING

C114698
  1. Remove the cam ring from the vane pump front housing.


7. REMOVE VANE PUMP FRONT SIDE PLATE

  1. C114699
    Remove the front side plate from the vane pump front housing.

  1. C107029E03
    Using a screwdriver, remove the O-ring from the front side plate.

  1. C114700
    Remove the O-ring from the vane pump front housing.


8. REMOVE VANE PUMP HOUSING OIL SEAL

  1. C114701E03
    Using a screwdriver and piece of cloth, pry out the oil seal.
    Text in Illustration 
    *a
    Cloth

    NOTICE:
    Be careful not to damage the vane pump front housing.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →