ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / Data List / DPNR Differential Pressure.
Disconnect the No. 6 exhaust pipe air hose from the sensor.
Using SST, apply pressure to the differential pressure sensor.

- SST
- 09992-00242
Text in Illustration *a
Pressure
*b
Front Side of Vehicle
Check the pressure value of the sensor.
- Standard pressure:
- Approximately the same pressure as the applied pressure is indicated on the tester.
- HINT:
- Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).
Connect the No. 6 exhaust pipe air hose to the differential pressure sensor.
