2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)

2. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR

  1. A244973
    Remove the 3 nuts and No. 1 front floor heat insulator.


3. REMOVE NO. 1 SENSOR BRACKET (for Automatic Transmission)

  1. A244974
    Detach the 4 clamps and disconnect the connector.

  1. Remove the bolt, nut and No. 1 sensor bracket.

  1. A244975
    Remove the bolt and sensor bracket.


4. REMOVE SENSOR BRACKET (for Manual Transmission)

  1. A244976
    Detach the clamp and disconnect the connector.

  1. Remove the bolt and sensor bracket.


5. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

  1. A244979
    Remove the nut and differential pressure sensor from the sensor bracket.

  1. A245677
    Remove the No. 6 exhaust pipe air hose and No. 7 exhaust pipe air hose from the differential pressure sensor.

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →