2013-2015 Land Cruiser Prado · Service Manual Brake

C0226 SFR Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The solenoid turns on when signals are received from the skid control ECU and controls the pressure acting on the wheel cylinders, thus controlling braking force.
DTC Code
DTC Detection Condition
Trouble Area
C0226
An open or short circuit in the SFRH or SFRR circuit continues for 0.05 seconds or more.
  1. SFRH or SFRR circuit
  2. Master cylinder solenoid
C0236
An open or short circuit in the SFLH or SFLR circuit continues for 0.05 seconds or more.
  1. SFLH or SFLR circuit
  2. Master cylinder solenoid
C0246
An open or short circuit in the SRRH or SRRR circuit continues for 0.05 seconds or more.
  1. SRRH or SRRR circuit
  2. Master cylinder solenoid
C0256
An open or short circuit in the SRLH or SRLR circuit continues for 0.05 seconds or more.
  1. SRLH or SRLR circuit
  2. Master cylinder solenoid
C1225
An open or short circuit in the SMCF circuit continues for 0.05 seconds or more.
  1. SMCF circuit
  2. Master cylinder solenoid
C1226
An open or short circuit in the SREA circuit continues for 0.05 seconds or more.
  1. SREA circuit
  2. Master cylinder solenoid
C1227
An open or short circuit in the SREC circuit continues for 0.05 seconds or more.
  1. SREC circuit
  2. Master cylinder solenoid
C1228
An open or short circuit in the STR circuit continues for 0.05 seconds or more.
  1. STR circuit
  2. Master cylinder solenoid

WIRING DIAGRAM

C220139E02

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. RECONFIRM DTC

HINT:
These codes are stored when a problem is detected in the master cylinder solenoid.
The solenoid circuit is in the master cylinder solenoid.
Therefore, solenoid circuit inspections and solenoid unit inspections cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

  1. Clear the DTCs (Click here).

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C0226 SFR Solenoid Circuit (+ 7 more codes) (Aug 2013 – Jul 2014)C0278 Open in ABS Solenoid Relay Circuit (+ C0279) (Aug 2013 – Jul 2014) →