2013-2015 Land Cruiser Prado · Service Manual Brake

C1251 Open in Pump Motor Circuit

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.
DTC Code
DTC Detection Condition
Trouble Area
C1251
There is an open in the motor system circuit (motor input circuit).
  1. Pump motor wire harness connection
  2. Brake booster with accumulator pump assembly
  3. Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

HINT:
Remove the hydraulic brake booster assembly before the inspection (for LHD: Click here, for RHD: Click here).


1. CHECK CONNECTION OF PUMP MOTOR WIRE HARNESS
  1. Remove the hydraulic brake booster assembly (for LHD: Click here, for RHD: Click here).

  1. Check the tightening torque of the 2 screws which secure the wire harness connecting the master cylinder solenoid and brake booster with accumulator pump assembly (for LHD: Click here, for RHD: Click here).

OK:
The harness is tightened to the specified torque.

Torque:
2.9 N*m{ 30 kgf*cm , 26 in.*lbf }



NG
RETIGHTEN SCREWS
OK


2. CHECK RESISTANCE OF PUMP MOTOR WIRE HARNESS
  1. Using a screwdriver, remove the 2 screws and pull out the wire harness from the master cylinder solenoid.

  1. C173363E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Red wire terminal - Black wire terminal
    Always
    Below 2 Ω

    Text in Illustration 
    *1
    Pump motor wire harness
    *a
    Red wire
    *b
    Black wire

HINT:
Refer to the brake booster with accumulator pump assembly installation procedures:
for LHD (Click here)
for RHD (Click here)



NG
REPLACE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY
OK


3. RECONFIRM DTC
  1. Reassemble the hydraulic brake booster assembly (for LHD: Click here, for RHD: Click here).

  1. Install the hydraulic brake booster assembly (for LHD: Click here, for RHD: Click here).

  1. Clear the DTCs (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1251 Open in Pump Motor Circuit (Aug 2013 – Jul 2014)C1252 Brake Booster Pump Motor on Time Abnormally Long (Aug 2013 – Jul 2014) →