2013-2015 Land Cruiser Prado · Service Manual Brake

C1257 Power Supply Drive Circuit

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.
DTC Code
DTC Detection Condition
Trouble Area
C1257
There is an open in the motor system circuit (motor input circuit).
Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. CHECK PUMP MOTOR OPERATION
  1. Turn the ignition switch off.

  1. Disconnect the A7 skid control ECU connector.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Check pump motor operation.

    OK:
    Pump motor operates normally.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


2. RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Reconnect the A7 skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Clear the DTCs (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1257 Power Supply Drive Circuit (Aug 2013 – Jul 2014)C1268 Transfer L4 Position Switch Circuit (Aug 2013 – Jul 2014) →