C1257 Power Supply Drive Circuit
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1257 |
There is an open in the motor system circuit (motor input circuit). |
Master cylinder solenoid (Skid control ECU) |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. CHECK PUMP MOTOR OPERATION |
Turn the ignition switch off.
Disconnect the A7 skid control ECU connector.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Check pump motor operation.
- OK:
- Pump motor operates normally.
Result Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 2. RECONFIRM DTC |
Turn the ignition switch off.
Reconnect the A7 skid control ECU connector.
Turn the ignition switch to ON.
Clear the DTCs (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD)
B
DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
