2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Rear Air Conditioning Control Panel Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit consists of the air conditioning control assembly and air conditioning amplifier. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control assembly is operated.

WIRING DIAGRAM

E157369E35

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the G24 amplifier connector.

  1. Disconnect the T3 control connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T3-3 (RLIN) - G24-13 (RLIN)
    Always
    Below 1 Ω
    T3-3 (RLIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)

  1. E196918E05
    Disconnect the T3 control connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    T3-5 (IG) - T3-8 (E)
    Ignition switch off
    Below 1 V
    T3-5 (IG) - T3-8 (E)
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T3-8 (E) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Air Conditioning Control Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE AIR CONDITIONING CONTROL ASSEMBLY
  1. Replace the air conditioning control assembly with a new or normally functioning one (Click here).

  1. Operate the air conditioning control assembly to check that it functions properly.

    OK:
    Air conditioning control assembly operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS FAULTY)


← Air Conditioning Compressor Magnetic Clutch Circuit (from Aug 2014)Rear Air Conditioning Control Panel Circuit (from Aug 2014) →