This circuit consists of the air conditioning control assembly and air conditioning amplifier. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system. If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control assembly is operated.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)
Disconnect the G24 amplifier connector.
Disconnect the T3 control connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
T3-3 (RLIN) - G24-13 (RLIN)
Always
Below 1 Ω
T3-3 (RLIN) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)
Disconnect the T3 control connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
T3-5 (IG) - T3-8 (E)
Ignition switch off
Below 1 V
T3-5 (IG) - T3-8 (E)
Ignition switch ON
11 to 14 V
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
T3-8 (E) - Body ground
Always
Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector (to Air Conditioning Control Assembly)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
3. REPLACE AIR CONDITIONING CONTROL ASSEMBLY
Replace the air conditioning control assembly with a new or normally functioning one (Click here).
Operate the air conditioning control assembly to check that it functions properly.
OK:
Air conditioning control assembly operates normally.
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)