C1782/82 Low Battery Positive Voltage
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1782/82 |
The voltage at terminal IG or B is 10 V or less or 16 V or higher for 0.5 seconds. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the suspension control ECU, perform registration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the suspension control ECU, perform registration (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (IG/+B POWER SOURCE VOLTAGE) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / Air suspension / Data List.
Air Suspension Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
IG Power Source Voltage
Actual ECU power supply voltage / Min.: 0.0 V, Max.: 25.5 V
Ignition switch ON: 11 to 14 V
-
+B Power Source Voltage
Actual battery supply voltage / Min.: 0.0 V, Max.: 25.5 V
Ignition switch ON: 11 to 14 V
-
- Standard voltage:
- 11 to 14 V
Result Result
Proceed to
NG
A
OK (When troubleshooting according to problem symptoms table)
B
OK (When troubleshooting according to DTC chart)
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK TERMINAL VOLTAGE (IG, B) |
Disconnect the A49 suspension control ECU connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
A49-3 (B) - Body ground
Always
11 to 14 V
A49-1 (IG) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Suspension Control ECU)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - BODY GROUND) |
Disconnect the A49 and R19 suspension control ECU connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R19-10 (GND) - Body ground
Always
Below 1Ω
A49-5 (GND) - Body ground
Always
Below 1Ω
|
|
||||
| OK | |
| 4. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | ||
| ||
