C1792/92 Height Control Switch Circuit (Test Mode DTC)
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The vehicle height can be adjusted by pressing the height control switch.By pressing the "up" side, vehicle height is raised.
By pressing the "down" side, vehicle height is lowered.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1792/92 |
The height control switch signal does not change. |
|
- HINT:
- This DTC is stored only during test mode.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the suspension control ECU, perform registration (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (HEIGHT CONTROL SWITCH) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / Air suspension / Data List.
Air Suspension Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Height Control Switch (UP)
Height control switch ("up" side) / ON or OFF
ON: Switch is pressed and held
OFF: Switch is not pressed
-
Height Control Switch (DOWN)
Height control switch ("down" side) / ON or OFF
ON: Switch is pressed and held
OFF: Switch is not pressed
-
Check that the value displayed on the intelligent tester changes by pressing the height control switch "up" side or "down" side.
- OK:
- Height control switch value changes.
|
|
||||
| OK | ||
| ||
| 2. INSPECT CENTER CLUSTER MODULE SWITCH |
Turn the ignition switch off.
Remove the height control switch (center cluster module switch) (Click here).
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
7 (LO) - 24 (E)
"Down" pressed
Below 1 Ω
7 (LO) - 24 (E)
"Up" pressed
10 kΩ or higher
6 (HI) - 24 (E)
"Down" pressed
10 kΩ or higher
6 (HI) - 24 (E)
"Up" pressed
Below 1 Ω
Text in Illustration *a
Component without harness connected
(Height Control Switch (Center Cluster Module Switch))
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (CENTER CLUSTER MODULE SWITCH - SUSPENSION CONTROL ECU) |
Disconnect the G156 height control switch (center cluster module switch) connector.
Disconnect the A49 suspension control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G156-6 (HI) - A49-15 (UPSW)
Always
Below 1 Ω
G156-7 (LO) - A49-14 (DNSW)
Always
Below 1 Ω
G156-24 (E) - Body ground
Always
Below 1 Ω
G156-6 (HI) or A49-15 (UPSW) - Body ground
Always
10 kΩ or higher
G156-7 (LO) or A49-14 (DNSW) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
