2013-2015 Land Cruiser Prado · Service Manual Suspension

C1794/94 Height Control OFF Switch Circuit (Test Mode DTC)

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

If the height control OFF switch is pressed when the vehicle is stopped with the engine running or the ignition switch ON, vehicle height control is disabled and remains disabled even after the ignition switch is turned off. Pressing the height control OFF switch again with the engine running or the ignition switch ON resumes vehicle height control. If the vehicle speed reaches approximately 30 km/h (19 mph) when vehicle height control is disabled, vehicle height control automatically resumes.
DTC Code
DTC Detection Condition
Trouble Area
C1794/94
Stored only during test mode.
  1. Height control OFF switch (Center cluster module switch)
  2. Harness or connector
  3. Suspension control ECU

WIRING DIAGRAM

C218604E04

INSPECTION PROCEDURE

NOTICE:
When replacing the suspension control ECU, perform registration (Click here).


1. INSPECT CENTER CLUSTER MODULE SWITCH
  1. Remove the height control OFF switch (center cluster module switch) (Click here).

  1. C296052E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (N) - 24 (E)
    Height control OFF switch pressed
    Below 1 Ω
    Height control OFF switch not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Height Control OFF Switch (Center Cluster Module Switch))



NG
REPLACE CENTER CLUSTER MODULE SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - CENTER CLUSTER MODULE SWITCH)
  1. Disconnect the A49 suspension control ECU connector.

  1. Disconnect the G156 height control OFF switch (center cluster module switch) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A49-13 (TD) - G156-5 (N)
    Always
    Below 1 Ω
    A49-13 (TD) or G156-5 (N) - Body ground
    Always
    10 kΩ or higher
    G156-24 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU (Click here)


← C1792/92 Height Control Switch Circuit (Test Mode DTC) (from Aug 2014)C1794/94 Height Control OFF Switch Circuit (Test Mode DTC) (from Aug 2014) →