Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
Horn Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the horns to sound. WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HORN OPERATION
Press the horn switch and check if the horns sound.
OK:
Horns operate normally.
NG
OK
2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VEHICLE HORN)
Operate the intelligent tester according to the steps on the display and select Active Test (Click here ).
Main Body
Tester Display
Test Part
Control Range
Diagnostic Note
Vehicle Horn
Vehicle horns
ON/OFF
-
OK:
Horns operate normally.
NG
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )
3. CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - MAIN BODY ECU)
Disconnect the 1A relay connector.
Remove the main body ECU (Click here ).
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
1A-7 - A-28 (HORN)
Always
Below 1 Ω
1A-7 or A-28 (HORN) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here )