2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Horn Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the horns to sound.

WIRING DIAGRAM

B224123E16

INSPECTION PROCEDURE


1. CHECK HORN OPERATION
  1. Press the horn switch and check if the horns sound.

    OK:
    Horns operate normally.



NG
GO TO HORN SYSTEM (Click here)
OK


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VEHICLE HORN)
  1. Operate the intelligent tester according to the steps on the display and select Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -

    OK:
    Horns operate normally.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - MAIN BODY ECU)
  1. Disconnect the 1A relay connector.

  1. Remove the main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1A-7 - A-28 (HORN)
    Always
    Below 1 Ω
    1A-7 or A-28 (HORN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← Engine Hood Courtesy Switch Circuit (from Aug 2014)Horn Circuit (from Aug 2014) →