C1381 Acceleration Sensor Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
These DTCs are also stored when calibration has not been completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1381 |
At a vehicle speed of more than 3 km/h (2 mph), the acceleration sensor power source malfunction signal is received for 10 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and acceleration sensor, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the yaw rate and acceleration sensor, perform calibration (Click here).
| 1. CHECK TERMINAL VOLTAGE (IG) |
Disconnect the G52 yaw rate and acceleration sensor connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
G52-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Yaw Rate and Acceleration Sensor)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (GND TERMINAL) |
Disconnect the G52 yaw rate and acceleration sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G52-1 (GND) - Body ground
Always
Below 1 Ω
- NOTICE:
- Check the yaw rate and acceleration sensor signal after replacement (Click here).
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Reconnect the yaw rate and acceleration sensor connector.
Clear the DTCs (Click here).
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1381 is not output
A
DTC C1381 is output
B
|
|
||||
| A | ||
| ||
