2013-2015 Land Cruiser Prado · Service Manual Steering

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedures to troubleshoot the steering lock system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK DTC*
    1. Check for DTCs and make a note of any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here). Based on the DTCs output above, try to cause the output of the same wireless door lock control system DTC, LIN communication system DTC, steering lock system DTC, engine immobiliser system DTC or entry and start system (for entry function) DTC by reproducing the symptoms indicated by the DTC.

      Result 
      Result
      Proceed to
      DTC is not output.
      A
      Wireless door lock control system DTC is output.
      B
      LIN communication system DTC is output.
      C
      Steering lock system DTC is output.
      D
      Engine immobiliser system DTC is output.
      E
      Entry and start system (for entry function) DTC is output.
      F


    B.

    C.

    D.

    E.

    F.
    A

    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table.
      A
      Fault is listed in problem symptoms table.
      B


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List / Active Test (Click here).

    NEXT

    6.REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014) →