2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2780 Push Switch / Key Unlock Warning Switch Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is on when the ignition switch is ON.
DTC Code
DTC Detection Condition
Trouble Area
B2780
The unlock warning switch assembly is not detected as being on when the ignition switch is ON.
  1. Transponder key ECU assembly
  2. Unlock warning switch assembly
  3. Harness or connector

WIRING DIAGRAM

B242195E14

INSPECTION PROCEDURE

NOTICE:
When replacing the transponder key ECU assembly, refer to the Service Bulletin.


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2780 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

  1. E198930
    Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU AND BODY GROUND)
  1. Disconnect the G3 switch connector.

  1. Disconnect the G138*1 or G74*2 ECU connector.

    1. *1: for 5L-E
    2. *2: except 5L-E

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 5L-E 
    Tester Connection
    Condition
    Specified Condition
    G138-3 (KSW) - G3-1
    Always
    Below 1 Ω
    G138-3 (KSW) or G3-1 - Body ground
    Always
    10 kΩ or higher
    G3-2 - Body ground
    Always
    Below 1 Ω
    except 5L-E 
    Tester Connection
    Condition
    Specified Condition
    G74-3 (KSW) - G3-1
    Always
    Below 1 Ω
    G74-3 (KSW) or G3-1 - Body ground
    Always
    10 kΩ or higher
    G3-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014)B2784 Antenna Coil Open / Short (from Aug 2013) →